Spareparts
PROJECT - Hinge Set
Original Hinge replacements
-- In Stock --
This hinge set allows for the easy detachment of the turntable's supplied lid, and allows the lid to open/close easily. Please note different Pro-Ject turntables use a different part code hinge, so please select carefully to ensure the correct one i...
PROJECT - Replacement Power Supply
16VAC, 500mA.
-- In Stock --
Replacement for defective power supply for ProJect Debut and other models (16VAC Models)
European Schuko mains connector. (Not suitable for the UK)
Primary Voltage 230VAC, Secundary Voltage 16VAC, Current 500mA
PROJECT - Cover for Project - Small
Original replacement
-- In Stock --
There's no need to suffer the indignity of a broken or scuffed up dust cover on your Pro-Ject Debut turntable! Simply replace the dust cover with a new one! Replacing the old cover is very easy, requiring only a pair of hands and the ability to gent...
PROJECT - Cover for Project - Standard 2.1
Original replacement for 2-xperience
-- Sold Out -- But expected in again!
The Pro-Ject Cover It Srandard 2 cover is the original cover of your Pro-ject 2-Xperience SB DC turntable or your Pro-Ject 2-Xperience Acryl DC turntable.
It will brilliantly replace your old scratched or cracked dust cover and give a new look to your tu
PROJECT - Tonearm 8.6 Carbon Upgrade
8.6inch Carbon Tonearm replacement
-- In Stock --
This is the well known 8,6 inch Carbon Tonearm from Project. It is a nice upgrade for a standard project Debut or Debut-II. Length 218.5mm, Eff.armmass 6.0 grams, overhang 18,5mm
Easy slot-in for Debut models. For Debut with fixed armcable you will ...
REGA - Cable TT-PSU to Rega RP recordplayer
When you lost yours......
-- In Stock --
Replacement cable to connect the Rega TT-PSU to your Rega RP3 (or higher) turntable. Standard length.
WBT - Spade 6mm =box 4pcs =
4x
-- In Stock --
nextgen Sandwich Spade NEW Version
Signature spade made from fine silver
PROJECT - Finger Lift ( Fingertip )
-- In Stock --
The use of a finger lift on Pro-Ject record players allows for greater control over the tonearm, and more accurate alignment when cueing a record.
This replacement finger lift uses the cartridge's mounting screws to fix itself to the top of the tonearm
